Skip to content
Pass Duke Elder
Textbook / Chapter 3 / Optics, refraction and visual science

Prisms and the Prentice rule

A prism bends light without focusing it. That simple property is used to measure a squint, to relieve double vision and inside most ophthalmic instruments. It also explains why looking through the edge of a spectacle lens shifts the image. This lesson covers the prism dioptre, base direction, the Prentice rule and decentration, with worked examples.

8 minute read7 linked questions

What a prism does

A prism is a wedge of transparent material with two flat faces that meet at the apex. The thick end opposite is the base. Because the prism material has a higher refractive index than air, light is bent at both faces, each time towards the base. The emerging ray has changed direction but not vergence: parallel light stays parallel. A prism therefore has no focusing power. It only deviates.

Now look through the prism. The light reaching your eye has been turned towards the base, and the eye traces it straight back. The object therefore appears shifted towards the apex. This is the rule that everything else follows from: light is deviated towards the base, and the image is displaced towards the apex.

A prism also bends blue light more than red, because refractive index is higher for short wavelengths. That is why a strong prism gives coloured fringes and splits white light into a spectrum.

The prism dioptre

Prism power is measured by how far the light is displaced at a set distance. One prism dioptre (written with the symbol Δ) displaces a ray by 1 cm at a distance of 1 m.

Prism power (Δ) = displacement in cm / distance in metres1 Δ is 1 cm of displacement at 1 m.

Worked example 1. A prism shifts a spot of light by 6 cm on a wall 2 m away. Its power is 6 / 2 = 3 Δ.

Worked example 2. A patient needs 10 Δ to align the eyes. At 1 m that is a displacement of 10 cm. At 6 m it is 60 cm.

Prism dioptres are not the same as degrees. A displacement of 100 cm at 100 cm is an angle of 45 degrees, so 100 Δ is 45 degrees, not 100. For the small angles met in clinic, 1 degree is about 1.75 Δ, so a deviation in prism dioptres is a little less than twice its size in degrees.

Lenses as prisms: the Prentice rule

A spherical lens can be pictured as a stack of prisms. A plus lens is thick in the centre, so it behaves like prisms placed base to base, with every base pointing towards the centre. A minus lens is thick at the edge, like prisms placed apex to apex, with every base pointing away from the centre. At the very centre the two faces are parallel and there is no prism. This point is the optical centre.

The further from the optical centre you look, the more prism you meet. The amount can be worked out from first principles. A ray of parallel light striking a lens c centimetres from its centre is bent so that it crosses the axis at the focal point, which is 1 / F metres away. It has been displaced c cm over 1 / F m, and displacement in cm divided by distance in metres is prism dioptres. This gives the Prentice rule.

P = c × FP is the induced prism in prism dioptres, c the distance from the optical centre in centimetres, F the lens power in dioptres.

Worked example 1. A patient looks 5 mm below the optical centre of a +4.00 D lens. c = 0.5 cm, so P = 0.5 x 4 = 2 Δ. The lens is plus, so the base points towards the centre, which is above the line of sight: 2 Δ base up.

Worked example 2. A -6.00 D lens is fitted with its optical centre 5 mm nasal to the pupil. P = 0.5 x 6 = 3 Δ. The eye is looking through a point temporal to the centre, and in a minus lens the base points away from the centre, so the effect is 3 Δ base out.

Decentration can be deliberate. If a patient needs a small prism and already wears a reasonably strong lens, the optician can shift the optical centre instead of grinding in a prism. Rearranging the rule, the shift needed is c = P / F. To obtain 2 Δ from a +5.00 D lens the centre is moved 2 / 5 = 0.4 cm, or 4 mm, in the direction the base is wanted.

Unwanted prism and anisometropia

If both lenses have the same power, the two eyes meet the same prism when they look off-centre and the images move together. The trouble starts in anisometropia, where the two eyes need different powers.

The same effect explains why the face of a highly myopic person seems to step inwards behind the edge of their glasses, and why spectacles alter the effort of convergence. When a myope converges to read, each eye looks through the nasal part of a minus lens and meets base-in prism, which reduces the convergence needed. A hypermetrope in plus lenses meets base-out prism and must converge more.

Base direction and the squinting eye

Base direction is named relative to the patient: base in (towards the nose), base out (towards the temple), base up and base down. A prism prescription always states both the power and the base direction.

To neutralise a deviated eye, the image must be moved to where the eye is actually pointing. The image moves towards the apex, so the apex points in the direction of the deviation and the base points the opposite way.

DeviationEye positionBase direction
Esotropia or esophoriaTurned inBase out
Exotropia or exophoriaTurned outBase in
HypertropiaTurned upBase down over that eye
HypotropiaTurned downBase up over that eye
Prism needed to neutralise a deviation

Horizontal prism in front of the two eyes adds when the bases point the same way relative to the nose: 5 Δ base out right with 5 Δ base out left gives 10 Δ base out in total. Vertical prism adds when the bases are opposite: base down in front of the right eye does the same job as base up in front of the left. Splitting a prism between the eyes in this way keeps each lens thinner and lighter.

Measuring strabismus with prisms

In the prism cover test the examiner first shows a deviation with the cover test, then holds prisms of increasing power in front of one eye, apex towards the deviation, while alternately covering the eyes. The power at which the eyes no longer move to take up fixation is the size of the deviation in prism dioptres. It is repeated for distance and near. Where the patient cannot fixate with one eye, the Krimsky test uses the same prisms but the end point is the corneal light reflexes becoming symmetrical. The strabismus lessons cover these tests in detail.

The deviation produced by a prism depends on how it is held, and prisms are calibrated for one position.

PositionWhat it meansUsed for
Prentice positionThe back face is at right angles to the line of sightGlass prisms
Frontal plane positionThe back face is parallel to the plane of the facePlastic prism bars
Minimum deviationLight enters and leaves at equal angles, giving the smallest possible deviationLoose plastic prisms; in practice close to the frontal plane position
How prisms are held

Prisms as treatment

Prisms do not straighten the eyes. They move the image so that it falls on the fovea of the deviated eye, which can restore single vision. They suit small, stable deviations. Larger prisms are heavy and blur and colour the image, and StatPearls suggests considering referral for surgery once more than about 10 Δ is needed.

A Fresnel prism is a thin plastic sheet made of many tiny parallel prisms that is pressed onto a spectacle lens. It is cheap, light and easy to change, so it is used as a trial or while a deviation is still changing, for example after a recent cranial nerve palsy. Its drawback is reduced image quality. Once the deviation is stable, prism can be ground into the lens or produced by decentration. Prisms are also used to move a nystagmus null point towards the straight-ahead position and to shift the image in visual field loss, although the power required often limits their usefulness.

Summary

  • A prism deviates light towards its base without changing vergence, and the image is displaced towards the apex.
  • One prism dioptre is a displacement of 1 cm at 1 m, and 100 prism dioptres is 45 degrees.
  • The Prentice rule is P = c x F, with c in centimetres from the optical centre.
  • A plus lens acts as prisms base to base and a minus lens as prisms apex to apex.
  • Decentring a plus lens gives base in the direction of the shift, and a minus lens gives base in the opposite direction.
  • Unequal lens powers give unequal induced prism away from the optical centres, which can cause vertical diplopia on reading.
  • To neutralise a deviation the apex points towards the deviation: base out for esotropia and base in for exotropia.
  • Glass prisms are calibrated for the Prentice position and plastic prism bars for the frontal plane position.
  • Prisms of the same direction should not be stacked over one eye, so large deviations are split between the eyes.
  • Fresnel prisms are thin press-on prisms used for trial or temporary correction at the cost of image quality.

Check yourself

Quick recall on this lesson. These are easier than the question bank.

1. A prism displaces an image by 8 cm at 2 m. What is its power?
2. A patient looks through a point 1 cm above the optical centre of a -3.00 D lens. What prism is induced?
3. Which prism neutralises an esotropia?
4. Through a prism, an object appears displaced towards the:
Practise 7 questions on this lesson

Written for revision. It is not a source of clinical advice, and guidance changes.