Skip to content
Pass Duke Elder
Textbook / Chapter 3 / Optics, refraction and visual science

The optics of the eye: emmetropia, myopia and hypermetropia

The eye is a plus lens system of about 60 dioptres that must focus on a retina about 24 mm behind the cornea. This lesson explains where that power comes from, the simplified model eyes used for calculation, and what goes wrong in myopia, hypermetropia and aphakia. The idea of the far point makes the choice of correcting lens obvious.

9 minute read8 linked questions

Where the eye's power comes from

Light entering the eye crosses the tear film and cornea, the aqueous, the crystalline lens and the vitreous before reaching the retina. Only two of these do much focusing: the cornea and the lens. Together they give the relaxed eye a power of about +60 D.

The cornea supplies about two thirds of this, a little over 40 D. It is so powerful because its front surface separates air (index 1.00) from corneal tissue (1.376), the largest step in refractive index anywhere in the eye, across a steeply curved surface. The lens supplies the remaining third, around 20 D in the relaxed adult eye. It sits between aqueous and vitreous, whose indices (about 1.336) are close to its own, so each of its surfaces bends light only modestly. What the lens has that the cornea lacks is the ability to change power, which is the subject of the next lesson.

3D atlasThe two refracting elements, cornea and lens, and the fovea where the image must fall.

Model eyes

Real eyes are too complicated to calculate with, so simplified models are used. The schematic eye, associated with Gullstrand, represents each refracting surface of the cornea and lens with its own curvature, position and index. It is accurate but laborious. Published versions give total powers between about 58 and 60 D depending on the assumptions made, so do not be thrown by small differences between books.

The reduced eye goes further. It replaces the whole system with a single curved surface of +60 D separating air from a medium with the index of water. Because the image space is filled with fluid, the two focal lengths differ. The front focal length is 1 / 60 m, about 17 mm. The back focal length is the index divided by the power, 1.33 / 60 m, about 22 mm, which is roughly the length of the model eye. Rays aimed at the nodal point pass through undeviated, and in the reduced eye it lies about 17 mm in front of the retina.

That one number lets you calculate the size of a retinal image by similar triangles, since an undeviated ray from the top of the object passes through the nodal point to the top of the image.

Image height / 17 mm = object height / object distanceObject distance is measured to the nodal point. For distant objects, the distance to the eye is near enough.

Worked example. A sign 1 m tall is viewed from 17 m. Image height = 17 mm x (1 / 17) = 1 mm. The same sign at 34 m gives an image of 0.5 mm. The retinal image is real, inverted and very small.

Emmetropia and the far point

An eye is emmetropic when, with its focusing relaxed, parallel light from a distant object is brought to a focus exactly on the retina. Power and length are matched. Ametropia is any mismatch, and the two spherical forms are myopia and hypermetropia.

The most useful idea in this topic is the far point: the point in space that is in focus on the retina when the eye is fully relaxed. For an emmetrope it is at infinity. A correcting lens has one job, which is to take parallel light from a distant object and make it appear to come from the far point. So the correcting lens is the lens whose focal point lies at the far point.

Refractive error (D) = 1 / far point distance in metresMinus if the far point is in front of the eye (myopia), plus if it is behind the eye (hypermetropia). Vertex distance is ignored here.

Myopia

In myopia (short sight) the eye is too powerful for its length. Parallel light focuses in front of the retina and has spread into a blur circle by the time it arrives. Divergent light from a near object focuses further back, so there is a distance at which objects are sharp. That distance is the far point, and it lies a finite distance in front of the eye. Anything beyond it is blurred.

Worked example 1. A patient sees clearly only out to 50 cm. The far point is 0.5 m in front of the eye, so the error is 1 / 0.5 = 2 D of myopia and the correction is -2.00 D. A minus lens makes parallel light diverge as if from its focal point, 50 cm in front, exactly where this eye can focus. A far point at 25 cm means -4.00 D, and at 10 cm, -10.00 D.

The usual cause is an eye that is too long, axial myopia. Each millimetre of extra axial length adds about 3 D of myopia. Less often the length is normal and the power is too high, refractive myopia: a cornea that is too steep, as in keratoconus, or a lens whose refractive index has risen, as in nuclear sclerotic cataract. The latter is index myopia and explains the older patient who is pleased to find they can read without glasses again.

Hypermetropia

In hypermetropia (long sight, also called hyperopia) the eye is too weak for its length. Parallel light is heading for a focus behind the retina. Light would have to arrive already converging to focus on the retina of the relaxed eye, so the far point is virtual and lies behind the eye. The correction is a plus lens. The usual cause is a short eye, and each millimetre of shortening gives about 3 D of hypermetropia. A flat cornea or the absence of the lens are refractive causes.

Worked example 2. An eye is 2 mm shorter than an emmetropic eye of the same power. The expected error is about 2 x 3 = 6 D of hypermetropia, corrected by about +6.00 D. The same eye 2 mm too long would be about -6.00 D.

The difference from myopia is that a young hypermetrope can supply the missing plus power by accommodating, even for distance. Vision may be perfect, at the cost of constant focusing effort, with more needed for near. This gives hypermetropia its vocabulary.

  • Latent hypermetropia is the part hidden by the resting tone of the ciliary muscle. It is revealed only by cycloplegic drops.
  • Manifest hypermetropia is the part found without cycloplegia. It is the strongest plus lens that still gives the best acuity.
  • Facultative hypermetropia is the part of the manifest error that the patient can overcome by accommodating.
  • Absolute hypermetropia is the part that cannot be overcome. It is the weakest plus lens that gives the best acuity.
  • Total = latent + manifest, and manifest = facultative + absolute.
MyopiaHypermetropia
Parallel light focusesIn front of the retinaBehind the retina
Power relative to lengthToo strong, or eye too longToo weak, or eye too short
Far pointReal, in front of the eyeVirtual, behind the eye
Correcting lensMinus (concave)Plus (convex)
Effect of accommodationMakes distance vision worseCan compensate when young
Uncorrected visionDistance blurred, near clearMay be clear when young; near fails first
1 mm of axial lengthAbout 3 D per mm too longAbout 3 D per mm too short
Myopia and hypermetropia compared
Optics benchLengthen and shorten the eye to see the focus move in front of and behind the retina, then add a minus or plus lens to bring it back.

Aphakia

Aphakia is absence of the crystalline lens, most often after cataract surgery without an implant, or after lens dislocation. The eye loses about a third of its power and becomes highly hypermetropic. It also loses all accommodation, so a separate near correction is always needed.

Aphakia can be corrected at three places: in a spectacle frame, on the cornea or inside the eye. The further the correcting lens is from the eye, the more it magnifies the retinal image. A strong plus spectacle lens enlarges the image markedly, causes distortion and a ring-shaped blind zone around the edge of the lens. Objects vanish into this zone and reappear, the jack-in-the-box effect. As a rough guide each dioptre of difference between the eyes gives about 1 per cent difference in image size, and the brain tolerates only about 3 to 5 per cent. This unequal image size is aniseikonia. Spectacles therefore cannot give binocular vision when only one eye is aphakic.

A contact lens sits much closer to the eye and reduces the magnification enough to be tolerated. An intraocular lens placed where the natural lens was removes the problem almost completely, which is why an implant is the standard at cataract surgery. An eye with an implant is pseudophakic. It still cannot accommodate with a standard single-focus implant.

Summary

  • The relaxed eye has about +60 D of power, about two thirds from the cornea and one third from the lens.
  • The cornea is the main refracting element because of the large index step from air to cornea.
  • The reduced eye is a single +60 D surface with a nodal point about 17 mm in front of the retina.
  • Retinal image height is 17 mm multiplied by object height over object distance.
  • The far point is the point focused on the retina by the relaxed eye, and the correcting lens has its focal point there.
  • In myopia light focuses in front of the retina, the far point is in front of the eye and the correction is a minus lens.
  • In hypermetropia light focuses behind the retina, the far point is virtual and behind the eye, and the correction is a plus lens.
  • Each millimetre of axial length change is worth about 3 D.
  • Total hypermetropia is latent plus manifest, and latent hypermetropia is only revealed by cycloplegia.
  • Aphakia causes high hypermetropia with no accommodation, and spectacle correction magnifies the image and causes aniseikonia.

Check yourself

Quick recall on this lesson. These are easier than the question bank.

1. An uncorrected myope can see clearly no further than 20 cm. What is the refractive error?
2. Where is the far point of a hypermetropic eye?
3. Which part of the eye provides most of its refractive power?
4. Which type of hypermetropia is revealed only by cycloplegia?
Practise 8 questions on this lesson

Written for revision. It is not a source of clinical advice, and guidance changes.