Skip to content
Pass Duke Elder
Textbook / Chapter 2 / Ocular physiology and biochemistry

The tear film

The tear film is the thin layer of fluid that coats the cornea and conjunctiva. This lesson covers what it is made of, where each part comes from, what it does, and how its stability and volume are measured. Dry eye, the commonest ocular surface disease, is a failure of this system, so the physiology explains the clinical tests.

8 minute read4 linked questions

What the tear film is for

The cornea has to be transparent, so it has no blood vessels. It also has to be optically smooth, yet its surface cells are microscopically rough. The tear film solves both problems. It fills in the irregularities of the epithelium to give a smooth refracting surface, and it carries oxygen and nutrients to a tissue that cannot receive them from blood.

The air to tear interface is the first refracting surface that light meets. If the film breaks up between blinks, the surface becomes irregular and vision blurs until the next blink. This is why patients with dry eye often describe vision that fluctuates and clears on blinking.

  • Optical: provides a smooth surface for refraction.
  • Lubrication: lets the lids slide over the globe without damaging the epithelium.
  • Nutrition: supplies oxygen and nutrients to the avascular corneal epithelium.
  • Defence: washes away debris and carries antimicrobial proteins.
  • Protection: keeps the epithelium wet and removes irritants through reflex tearing.

The volume involved is small. The tear film holds roughly 3 to 10 microlitres, is about 3 micrometres thick over the cornea, and is replaced at about 1 to 2 microlitres per minute. Its pH is close to 7.45.

The three layers and where they come from

The tear film is classically taught as three layers. From the cornea outwards these are the mucin layer, the aqueous layer and the lipid layer. The modern view is that the mucin and aqueous components mix to form a single gel that is rich in mucin near the epithelium and more watery further out, with a very thin lipid film floating on top. The three-layer model is still the one examined, and it still explains the diseases.

LayerSourceMain jobWhat failure causes
Lipid (outer)Meibomian glands in the tarsal plates, opening at the lid marginSlows evaporation and stops tears spilling over the lid marginEvaporative dry eye, as in meibomian gland dysfunction
Aqueous (middle)Main lacrimal gland, with the accessory lacrimal glands of Krause and Wolfring in the conjunctivaBulk of the film: carries oxygen, electrolytes and antimicrobial proteins, and flushes debrisAqueous-deficient dry eye, as in Sjogren syndrome
Mucin (inner)Mainly conjunctival goblet cells, with some from corneal and conjunctival epithelial cells and the lacrimal glandMakes the water-repelling epithelium wettable and anchors the aqueous layerUnstable film despite normal volume, as in vitamin A deficiency or conjunctival scarring
The layers of the tear film

The lipid layer is only about 50 to 100 nanometres thick. It is made of meibum, a mixture of wax esters, cholesterol esters and polar lipids such as phospholipids. The polar lipids sit against the water and act as a surfactant, and the non-polar lipids sit on top against the air. Because the lipid layer is what holds back evaporation, blocked or inflamed meibomian glands give a dry eye even when the lacrimal gland is working normally.

The mucin layer matters because the corneal epithelium is hydrophobic. Water placed on a greasy surface forms beads. The epithelial cells carry a coat of membrane-bound mucins called the glycocalyx, and goblet cells add secreted, gel-forming mucin on top. Together these lower surface tension so the aqueous layer can spread as a continuous film. Mucins also trap bacteria and debris so they can be swept away.

What is in the aqueous layer

The aqueous layer is mostly water with electrolytes, glucose and dissolved oxygen, plus a set of proteins made locally by the lacrimal gland. The proteins give tears their antimicrobial activity.

  • Lysozyme breaks down the peptidoglycan cell wall of bacteria. Tears contain more of it than any other body fluid.
  • Lactoferrin binds iron, which bacteria need to grow.
  • Secretory IgA is the main immunoglobulin of tears. It is made by plasma cells in the lacrimal gland and conjunctiva, and stops organisms attaching to the surface.
  • Lipocalin (tear-specific prealbumin) binds lipids and helps to keep the film stable.

Normal tear osmolarity is about 300 mOsm/L, and readings up to 308 mOsm/L are generally taken as normal. When too little aqueous is produced, or too much evaporates, the remaining tears become concentrated. This hyperosmolarity damages surface cells and drives inflammation, which damages the glands and goblet cells further. That cycle is the core of dry eye disease, whatever starts it.

Secretion, spreading and drainage

Three kinds of tears are described. Basal tears are the constant low-level secretion that keeps the surface wet. Reflex tears are a much larger flow produced in response to irritation. Closed-eye tears bathe the surface during sleep and have a different protein balance.

Reflex tearing is a neural arc. The afferent limb is the ophthalmic division of the trigeminal nerve, which supplies the cornea, conjunctiva and lids. The efferent limb is parasympathetic: secretomotor fibres that begin with the facial nerve and reach the lacrimal gland after relaying in the pterygopalatine ganglion. A corneal foreign body therefore makes the eye water, and a numb cornea loses that protective response. The anatomy of this pathway is covered in the anatomy chapter.

Tears are spread by blinking. Each blink sweeps the aqueous and mucin across the cornea and squeezes fresh lipid out of the meibomian glands, which then spreads over the new film as the eye opens. Tears leave the eye in two ways: some evaporate, and the rest drain through the puncta at the medial ends of the lids into the canaliculi, lacrimal sac and nasolacrimal duct. Anything that reduces blinking, such as concentrating on a screen, or that leaves the surface exposed, such as incomplete lid closure, increases evaporation.

Measuring stability: tear break-up time

Tear break-up time tests how stable the film is. Fluorescein is instilled, the patient blinks once and then keeps the eye open, and the examiner watches the film at the slit lamp under cobalt blue light. The time from the last complete blink to the first dark dry spot in the green film is the break-up time. A value under 10 seconds is abnormal.

A short break-up time means the film is unstable. It is typical of evaporative dry eye from meibomian gland disease and of mucin deficiency, but it is also reduced in aqueous deficiency. It tests quality more than quantity. Non-invasive methods, which watch a reflected pattern on the tear surface without fluorescein, measure the same thing.

Measuring volume: the Schirmer test

The Schirmer test measures how much aqueous the eye produces. A strip of filter paper is folded about 5 mm from one end and hooked over the lower lid at the junction of its middle and outer thirds. The patient closes the eyes gently, and after 5 minutes the length of wet paper is read in millimetres.

VersionHow it is doneWhat it measures
Schirmer I without anaestheticStrip placed on the unanaesthetised eyeBasal plus reflex secretion, because the paper irritates the eye
Schirmer I with anaesthetic (basic secretion test)Topical anaesthetic first, fornix dried, then the stripBasal secretion alone
Schirmer IIStrip in place while the nasal mucosa is irritated with a cotton budReflex secretion
Versions of the Schirmer test

Wetting of more than 15 mm in 5 minutes is taken as normal, and less than 5 mm indicates a clear aqueous deficiency. Published cut-offs for diagnosing dry eye differ: the Dry Eye Workshop used 10 mm in 5 minutes. The test is simple but varies a good deal from one occasion to the next, so it is interpreted alongside symptoms, break-up time and surface staining rather than alone.

Summary

  • The tear film gives the cornea a smooth optical surface, lubricates the lids, feeds the avascular epithelium and defends against infection.
  • The classical model has three layers: outer lipid, middle aqueous and inner mucin.
  • Meibomian glands make the lipid layer, which slows evaporation.
  • The lacrimal gland and the accessory glands of Krause and Wolfring make the aqueous layer, which contains lysozyme, lactoferrin and secretory IgA.
  • Conjunctival goblet cells make most of the mucin, which makes the hydrophobic epithelium wettable.
  • Reflex tearing has a trigeminal afferent limb and a parasympathetic efferent limb.
  • Tear break-up time measures film stability and is abnormal if under 10 seconds.
  • The Schirmer test measures aqueous production over 5 minutes: less than 5 mm is deficient and more than 15 mm is normal.
  • Schirmer I without anaesthetic measures basal plus reflex tears, and with anaesthetic it measures basal tears.
  • Dry eye is either aqueous-deficient or evaporative, and both end in tear hyperosmolarity and surface inflammation.

Check yourself

Quick recall on this lesson. These are easier than the question bank.

1. Which structure produces most of the lipid layer of the tear film?
2. Below what value is a fluorescein tear break-up time considered abnormal?
3. A Schirmer test is performed after instilling topical anaesthetic. What does it measure?
4. Which tear protein acts by binding iron?
Practise 4 questions on this lesson

Written for revision. It is not a source of clinical advice, and guidance changes.